آلة حاسبة هندسية
Voltage Coefficient (VCR) Error Calculator
كيفية قراءة الرسم التخطيطي. The top resistor changes value as the voltage across it rises, so the ratio at 20 kV is not the ratio you measured on the bench. The curve is that drift and dR/R is the error the calculator returns.
A thick film resistor is not the same value at 20 kV as on a bench meter. VCR is quoted in ppm per volt; this turns it into the resistance change and the divider error it causes.
المدخلات
النتائج
- R1 change
- -
- Ratio at 0 V
- -
- Ratio at working V
- -
- نسبة الخطأ
- -
- Output at working V
- -
الصيغة
ΔR/R = VCR × V / 1,000,000. Divider ratio = (R1 + R2) / R2; recalculate it with the shifted R1 to get the error.
ما لا تتضمنه الآلة الحاسبة
- TCR. The resistor also drifts with temperature and the two effects add. A part with −1 ppm/V and 25 ppm/°C can drift more from a 40 °C rise than from full voltage.
- غير الخطية. VCR is not perfectly linear; the quoted figure is typical at rated voltage.
- Self-heating. Current through R1 raises its temperature, which shifts the value again.
اختيار الأجزاء
Where the ratio matters, specify VCR explicitly: the مجموعة الأغشية السميكة المستوية is quoted for precision divider use, tolerance from 0.2%. For matched pairs, send the ratio and the voltage.
Send the calculated values and the duty: اطلب عرض أسعار فنيالرد خلال 6 ساعة.